Ako se motor iz IC glave Z-osi ne instalira kako treba, posledice će biti ozbiljne.

It’s a short circuit, you know what that is, right? You've probably encountered it with pick-and-place machines. But here’s a detail you might not know. Are you familiar with the IC head (TH)? How about the Z-axis motor? But you probably aren't familiar with the insulation layer on the motor coil, right?

When installing the IC head, you need to pay attention to the gap between the motor coil and the Z-axis bearing, as well as the magnets on both sides. If you're not careful, over time, the insulation layer on the Z-axis motor coil could get worn down, causing a short circuit. The Z-axis motor should be installed on the IC head first, and then the gap should be adjusted.

When adjusting the gap, make sure to observe carefully and handle it gently. These small details are something 99% of engineers don’t know. So, which one are you—one of the 99%, or the 1%?

Spreman si da podigneš posao sa Geekvalue?

Stručnjakovi i iskustvo sposobnosti Geekvalusa za povećanje vašeg znaka na sledeći nivo.

Kontaktirajte eksperta za prodaju

Prijavite se našem prodavnom timu da istražite prilagođena rešenja koje savršeno ispunjavaju vaša poslovna potreba i rješavaju sve pitanja koje možete imati.

Zahtev za prodaju

Pratite nas.

Ostanite povezani sa nama da otkrijete poslednje inovacije, ekskluzivne ponude i uvide koje će povećati vaš posao na sledeći nivo.

Захтен цитат